The EV Accessories Tesla Model S Tesla Model X Jack Pad Adapter Tool, a brand new innovative jack pad adapter tool that allows the safe jacking of a Tesla Model S or Tesla Model X.
This jack pad has been designed to reduce the risk of damaging the battery pack while using a trolley jack with a large saddle. or jack pad is produced from 6082 aluminium for high strength and it’s made to measure design means it is compatible with small and large saddled trolley jacks.
**BACK ORDERED ITEMS WILL BE DELIVERING TO UK CUSTOMERS EARLY MAY.**
A Jack Pad Adapter Tool Designed For The Model S or Model X.
The EV Accessories jack pad adapter tool is designed to fit the Tesla Model S and Model X jack pad exactly. This is ti ensure that your jack only applies pressure to the vehicles jacking position. The adapter tool enables your trolley jack saddle to maintain a safe clearance from the battery pack located in the cars floor pan.
Easy To Use Jack Pad.
Due to the design of the EV accessories jack pads for Tesla vehicles, the jack pad stays in place when in use. It can easily be removed when the job is complete. The three location pins allow the adapter tool to align correctly to the cars jack pad. It will stay in place without using magnets near the battery pack and high voltage cables that run down the side of the car.
The Science Behind our Tesla Jack Pad Tool.
The EV Accessories jack pad adapter tools are machined from high grade 6082 aluminium. This means that both small and large saddle plate trolley jacks can be used without the jack pad distorting. 6082 grade aluminiums properties include high strength in both tensile and proof stress tests, meaning it’s very strong. The Aluminium is also highly resistant to corrosion meaning it can be used in wet conditions.
Throughout the design and prototype process several materials including 3D printed versions were considered. It was proven that 3D printed plastic materials would be unsafe. This is due to the fact that it would only take one layer to have a slight adhesion issue during the printing stage to cause a structural failure. That failure could happen at any time in the life time of the pad and we wanted a safe durable strong product.
Due to the bio degradable and recycled properties of some 3D printed plastics, many of them are not UV safe and begin to brake down in just 50 days from the point of manufacturing. Ours is machined from aluminium.
Fits the Tesla Model S and Model X
It is NOT suitable for Tesla Model 3.
Jacking any vehicle can extremely dangerous. This product is intended to allow the user to place a car jack under the Model S or Model X in the correct position. This significantly reduces the risk of damage to the battery pack. It will not prevent the jack slipping in jacked incorrectly.
- Always jack your Tesla Model S and Model X on level ground.
- Never raise the vehicle more than required.
- Always read the Model S and Model X instruction manual before jacking for the first time.
- Always use axle stands when jacking as a safety measure.
- Use a chock under the opposite side wheel.
- Activate jack mode on vehicles with air suspension.
“Tesla” “Model S” “Model 3″and “Model X” are brands and or registered trademarks of Tesla Inc. The products on this website are not affiliated or endorse by Tesla or related persons or companies.